mayorquimby
12-29-2011, 08:17 PM
doing my rb26dett swap, everything is going good. i'm repinning my wire harness because the main connector (one that plugs into ecu) split in two. i pulled one off a Z32,there exactly the same.
ok, my question is about the stock boost solenoid. i want to get rid of it, but i'm wondering if it will pull a code if the ECU doesn't see it. from what i understand the solenoid will automatically open at 15 psi. i have a AEM tru boost that runs its own solenoid. any info would help, i don't think it's a big deal but i want to know before i remove it. i'm trying to thin down my engine harness as much as possible. anything not needed is gone. thanks for your time
ok, my question is about the stock boost solenoid. i want to get rid of it, but i'm wondering if it will pull a code if the ECU doesn't see it. from what i understand the solenoid will automatically open at 15 psi. i have a AEM tru boost that runs its own solenoid. any info would help, i don't think it's a big deal but i want to know before i remove it. i'm trying to thin down my engine harness as much as possible. anything not needed is gone. thanks for your time