jc91
12-28-2011, 07:42 PM
I was driving home the other day and my drivers side headlight randomly quit working. I got home and used a voltmeter to find out that (on the headlight plug) the green/yellow wire was getting ~10 volts at first and quickly dropped while the low beams were on, and the red/black wire was getting 0.6 volts when the high beams were on. On the passengers headlight, both of these wires were getting 12 volts.
I know that these two wire go back to the light switch so I followed them back and tapped into the back of the plug but the readings were still the same. At this point I am stuck and do not know what to do. I know little about wiring (the most complicated thing I have ever done was wire up a s13 sr/s13 chassis swap) and could use some help on what to check next.
I have swapped out the light switch with a known working one, swapped out all 4 of the relays, checked the fuses, and of course tried a new bulb. The last bit of information is that the drivers side fender harness has been chewed through a couple times, but I have replaced all of the damaged wires and they still look to be in good condition.
ANY help would be MUCH appreciated
I know that these two wire go back to the light switch so I followed them back and tapped into the back of the plug but the readings were still the same. At this point I am stuck and do not know what to do. I know little about wiring (the most complicated thing I have ever done was wire up a s13 sr/s13 chassis swap) and could use some help on what to check next.
I have swapped out the light switch with a known working one, swapped out all 4 of the relays, checked the fuses, and of course tried a new bulb. The last bit of information is that the drivers side fender harness has been chewed through a couple times, but I have replaced all of the damaged wires and they still look to be in good condition.
ANY help would be MUCH appreciated