Bee*R installation problems

[4drsleeper]

does anybody know how to install a Bee*R rev limiter on a 97 240sx OBDII? i found couple way of doing it on google but none of them works, so if anybody could help me i would really appreciate it

[keytops]

Clicky: .: Ultimate 240SX Guide: ECU Pinout Diagrams :. (http://www.midweststreets.com/240SX/ecupin.html)
click 97 240 bla bla

I dont have a Bee*r, but this should work

The green wire goes to Pin 1 for the ign signal
yellow goes to pin 40 for the Cam sensor
red black; dont steal power from your ecu run a wire to the unit from elsewhere same with the ground.
White goes to the E-brake, clutch or any other switched ground

[4drsleeper]

i just tried that, n it doesnt work. i have to find out which is 1 degree wire n the 180 degree wire from the ecu