H&R studs good or bad?

[Carisma•FR]

I'm wondering if I should use the longer studs that come with my H&R 20mm spacers. I remember one of the member here says they don't seal tight enough they may spin within the holes of the hubs? Anyone else use them without problems? Or should I just go ahead with the expensive Nismo ones?

BTW I have Attain 5 lugs conversion in the front.

[Tubed4evr]

I was one of the people who had problems. Here is the link to my thread (http://www.zilvia.net/f/showthread.php?s=&threadid=20777&highlight=h%26r+spacers)
I went with Nismo studs and they fit like a glove. Not everyone runs into a problem but be prepared to get some new ones in a hurry if they dont fit. Its not so bad if you know it might be coming but it is a PITA if its sprung on you.

Also I don't know how the fitment will be with your aftermarket hubs. I would give it a shot and be ready to order some if there are complications.


Ryan

[Carisma•FR]

Thanks Tubed4evr, your post is very informative.

You mentioned you had spoken to the representitive in H&R. Have you gotten any update info from him regarding the fitment issue?

I'll bring the studs over to my shop tomorrow to see how they fit into the Attains. I'll keep you guys posted.