Tictakman
09-06-2011, 11:29 AM
Hey guys,
Just bought a 98 kouki with a manual swap. Car didnt start without being pushed and dropping the clutch but Ive fixed that. I installed a turbo and Im having an issue with idle while cold but also/or if I rev the car up and let the rpms drop it will die, also if at a cruising speed at 3ish grand holding steady the car will seem to lose power and slowly drop to 1000 rpms if i dont give it more gas or let off...like it bogs out or something. I have timing at 20 degrees...
The car will rev fine and holds 20lbs vac at idle, seems to boost to 10lbs ok but feels a bit sluggish... I boost tested my lines and found a few leaks which I fix, ive also replaced the coolant temp sensor (ecu), cleaned out the air idle control valve, and the O2 sensor but havent had any luck. My turbo kit is below....
gapped plugs at .030
t3/t4
walbro fuel pump
z32 mafs with a 90 bend going into turbo inlet
38mm external gate
BOV not hooked up (to make sure its not leaking)
880CC Delphi injectors w resistors (need to redo these)
jyg fuel rail w external FPR at 39 psi
FMIC
R.S Enthalpy Rom Tune with jumper harness to S14
My next thought is knock sensor?
Any help would be wonderful.
Z
Just bought a 98 kouki with a manual swap. Car didnt start without being pushed and dropping the clutch but Ive fixed that. I installed a turbo and Im having an issue with idle while cold but also/or if I rev the car up and let the rpms drop it will die, also if at a cruising speed at 3ish grand holding steady the car will seem to lose power and slowly drop to 1000 rpms if i dont give it more gas or let off...like it bogs out or something. I have timing at 20 degrees...
The car will rev fine and holds 20lbs vac at idle, seems to boost to 10lbs ok but feels a bit sluggish... I boost tested my lines and found a few leaks which I fix, ive also replaced the coolant temp sensor (ecu), cleaned out the air idle control valve, and the O2 sensor but havent had any luck. My turbo kit is below....
gapped plugs at .030
t3/t4
walbro fuel pump
z32 mafs with a 90 bend going into turbo inlet
38mm external gate
BOV not hooked up (to make sure its not leaking)
880CC Delphi injectors w resistors (need to redo these)
jyg fuel rail w external FPR at 39 psi
FMIC
R.S Enthalpy Rom Tune with jumper harness to S14
My next thought is knock sensor?
Any help would be wonderful.
Z