PDA

View Full Version : Error code pulled


theFlowMasta
10-17-2003, 12:01 AM
hey i pulled my engine check code from the ecu and found out that its was the air temp. sensor, that sensor on the air box. i thought it was a bad sensor and so i go a new working one and still the engine check light is on and wen i pull it again tis the same erroe code, 41, and yes i did clear the 1st time after i installed hte new sensor..but i dunno wats the problem now..can u guys hlep me out a bit or atleast point me in the right direction?

thanks in advance
richard

orion::S14
10-17-2003, 07:22 AM
You sure you cleared it the first time???

If the CEL wasn't off for at least a few miles, then you didn't clear the codes...

Reset the ECU again, and let us know what it does...

I have instructions on my site, if you want another set/perspective on how to do it...

www.KA24DEvelopment.com (http://www.ka24development.com/ecu_codes.html)

Later - Brian