PDA

View Full Version : power steering line question


shigitySxSe
03-31-2011, 04:44 PM
My power steering is leaking and Im trying to figure out which line to replace. I think I have it figured out, theres a small metal line with 2 metal fittings on the end. Its a smaller line from the junction box to the rack and pinion.
What is this line called exactly? Can I just go to an auto parts store or what? It looks like its the cheaper of the lines to replace, but a little pain in the ass to get to.

shigitySxSe
03-31-2011, 07:38 PM
bum peh.....

angelz365
03-31-2011, 08:11 PM
i think your talking about the hardline if it goes from the rack and pinion to the pump itself then its the hardline if it goes from the rack and pinion to the reservoir the its the return line there about $100 somthing new from an auto store. hope that helped p.s. watever line it is if you figure it out and buy it make sure you thread it in good cuz its very easy to strip!!!

matts13vert
04-01-2011, 12:43 AM
you sure the hard line is leaking? most common place for leaks is the rubber high pressure line coming out of the pump.

Have a friend sit in the car while its running and have him steer to full lock and hold it a full lock for a few seconds, dont hold it there for very long though. While he holds it at full lock you visually inspect the hoses for a leak.

You should be able to visibly see a leak in the hi pressure line or hardline since there is normally 1000-1500psi in them at full lock.

Nizzan4u2nv
04-01-2011, 02:00 AM
Yea, its usually the hi pressure line that leaks. Get an isis stainless braided line or make your own.

zurud
04-01-2011, 03:47 AM
My hard line at the back of rack was leaking. I had to buy it from dealer. It's only $4.

shigitySxSe
04-02-2011, 11:08 AM
thanks guys...

yeah it looks like it is the hard line. the fittings on the end were a b*tch not strip. its out now. im calling around now to check if dealers do have this for 4 bucks like you got....

shigitySxSe
04-02-2011, 11:20 AM
wtf... the dealers i called only sell the whole damn setup and its like 400 some bucks...

I have my own tubing that i guess ill be bending. F

shigitySxSe
04-02-2011, 01:32 PM
ok. so I found one of the fittings (a close enough match anyway at a parts store)

What about this one that goes into the rack and pinion. Does anyone have this or know where I can find one? See attached pic...

Prime
04-02-2011, 02:37 PM
14mm x 1.5 is the thread pitch. You can find fittings at Summit, and that likely means the auto parts place can order them/will have them.

zurud
04-03-2011, 02:07 AM
Part #45942 is still avaiable for $4.17 . Part 45941 is lo longer avaiable. 45942 is the furthest right one.