Noob wheel fitment help with MB battles

[slipandflow]

I have a stock s14 and want to put on mb battles 17x9.5. I know I have to fender roll but do I have to fender roll too if I run with factory spec for camber? also running 235/35/17 front and 235/45/17 rear.

[turbo2nr]

you should be fine with just a roll with 235/40/17 all around

i was running
17x9.5+15 235/40/17 f (-2.1)
17x9.5+15 255/40/17 r (-2.4)

i rolled all around no pull

btw check out rimtuck.com you can find ppl with similar setup's there, or the wheel filament thread here ..

[Forge_55b]

you didn't mention offset so hard to really say

[slipandflow]

oops sorry +15.
Turbo2nr: and they sit flush? camber isnt that bad right?

[turbo2nr]

yup they sit really flush you could tell they were cambered from the back but it wasnt too bad..

[slipandflow]

hows the tire wear though?

[turbo2nr]

can give a full review but it will vary upon tire and wear rating..

i had yoko s-drive and i had maybe around 10k on all four tires and it maybe wore around 20% middle and outside and ~35% inside.. not to much different..

stock 240sx is cambered in from the factory fyi.. -2.5 is the limit of factory tolerance as per alignment rack

[slipandflow]

yeah they are cambered factory. Thanks a lot bro. Helped a lot.

[towlie]

Stock fenders, roll no pull. No spacer. S13

17x9.5 +15

http://184.72.239.143/mu/a6cd0b78-ef4e-8dcd.jpg

Fits alright lol. Battles are very stock fender friendly

[upsdude]

i had 245/40/17's on my old bronze battles(17x9.5 +15) and had poke like a mother lol...they stuck out like 3/4" to 1"