StryfeS13
01-10-2011, 05:01 PM
Located in Fresno, CA.
I guess I'm open to trades. Looking mainly for KA-T parts such as 480CC injectors, N62 MAF, etc.
Selling a T25 off an SR20. Has some side to side shaft play and a little in/out as well. Not sure if it needs a rebuild. Comes with the inlet shown, wastegate, and that's it. Just the turbo! A/R .80
90 shipped.
http://i1177.photobucket.com/albums/x343/Sickfire/DSCF1712Small.jpg
http://i1177.photobucket.com/albums/x343/Sickfire/DSCF1714Small.jpg
Also selling a 6:1 VORTECH FMU for a KA-T setup...will work for other engines too of course. 6:1 is good cause it's not too rich. 6 pounds of fuel pressure per 1 pound of psi. Not an eBay FMU, this is name brand.. Has a hole drilled so you can mount it to a strut tower brace as seen in pics. LESS THAN 20 MILES ON THIS.
130 shipped. Firm.
http://i1177.photobucket.com/albums/x343/Sickfire/DSCF1715Small.jpg
I guess I'm open to trades. Looking mainly for KA-T parts such as 480CC injectors, N62 MAF, etc.
Selling a T25 off an SR20. Has some side to side shaft play and a little in/out as well. Not sure if it needs a rebuild. Comes with the inlet shown, wastegate, and that's it. Just the turbo! A/R .80
90 shipped.
http://i1177.photobucket.com/albums/x343/Sickfire/DSCF1712Small.jpg
http://i1177.photobucket.com/albums/x343/Sickfire/DSCF1714Small.jpg
Also selling a 6:1 VORTECH FMU for a KA-T setup...will work for other engines too of course. 6:1 is good cause it's not too rich. 6 pounds of fuel pressure per 1 pound of psi. Not an eBay FMU, this is name brand.. Has a hole drilled so you can mount it to a strut tower brace as seen in pics. LESS THAN 20 MILES ON THIS.
130 shipped. Firm.
http://i1177.photobucket.com/albums/x343/Sickfire/DSCF1715Small.jpg