PDA

View Full Version : sr20det in s13 no power to sensors?


sr20_s13
12-27-2010, 09:55 PM
i have a 1989 240sx with a sr20det swap
so i was driving out of my neighborhood and the car just died on me rpms dropped to zero and car wont start up it will crank and i have power but will not start
i do not have any spark or fuel
maf sensor shows no power as well
i used noid lights on sensors to test power
i took a ground and touched it to my injector wire and the injectors will spray but only when i touch the ground to the injector wire?
checked all grounds in bay also all are good and grounded
ive checked all fuses tried tracing wires to find any problems but im puzzled
ive also tried 2 diff ecus
any ideas of why im not getting any power to sensors ?

codyace
12-28-2010, 12:32 AM
CHeck the main fuses in your engine bay. Sounds like you had a short in a main power fuse.

coup-emonster
01-03-2011, 01:10 AM
recheck all your grounds bro..i has to be a ground...if your injectors work when you ground them, that means that your have power (fuses are good) it has to be a ground somewhere, check the ground next to the fuse box near the kick panel on driver side right next to the interior fuse box...hope it helps and good luck bro.