anybody used the pte 5830 turbo

[Quicksilver_s13]

currently planning on swapping my holset hx35 for something more refined and i was thinking of getting the pte 5830 turbo. is anybody currently running this or has ran this turbo? if so what supporting mods did you have and what spool time, power levels at what psi, etc. did you see with this turbo? i'd like to see real world results just to better convince me on getting this turbo.

i have an s13 blacktop with full supporting mods(pistons, rods, cams, etc.) and am currently making 446hp at 21psi. looking for some better numbers but quicker spool time than my about 5000rpm spool up.



thanks! - kyle

[Quicksilver_s13]

excuse me....the pte 5857 turbo

[Racinjitter]

I run a 5857 on my z31 with a 3.0l v6... I get full 23 psi at 3800 rpm and made 608wtq with 406whp. I am running the .82 turbine housing. If you were to run a smaller ar, you could have the same spool up with your smaller engine.

Sent using Tapatalk, foo!

[[email protected]]

why don't you just get a smaller housing from BEP? (bullseye performance)