PDA

View Full Version : Ecu pins not making contact?


surreybc
11-27-2010, 08:17 PM
is it common for a used ecu not to plug in right? I bought an ecu off the net and some of the pin dont seem to be making good connection. If I wiggle the harness the car shuts off. I have 3 other computers and they dont do this on this car. the pins and plug all look completely normal.

Touge Noob S13
11-27-2010, 08:29 PM
Are the pins on it bent? Have you checked the connector to see if any of the little connectors inside are misaligned?

surreybc
11-27-2010, 11:52 PM
Are the pins on it bent? Have you checked the connector to see if any of the little connectors inside are misaligned?

everything looks perfect to the eye. cleaned the pins.

nismoman
11-28-2010, 01:16 PM
Might seem silly but are you sure it's bolted tight enough to the ecu?

jspaeth
11-28-2010, 01:44 PM
This can be an issue.....I had a month's worth of troubleshooting this summer due to high RPM misfires, and it turend out to be bad contact of one of the CAS sensor ground pins in the ECU harness because it wasn't quite pushed all the way in to the blue plastic thing that holds all the pins....

surreybc
11-28-2010, 03:15 PM
yep, they can be tightened too little or too much .