PDA

View Full Version : Check engine light no work on sr20det?


turboex
08-03-2003, 03:41 PM
Ok i followed the wiring just as srswap.com says and still no check engine light, i have yet to see it light up. I know the ecu requires the wire from the light to run to it, but i can only find the wire on the car side. its a red wire according to my fsm but what pin does it go to on the sr20det redtop ecu? thanks

Racer X
08-03-2003, 08:07 PM
mines dosent work either if that makes you feel better. but i dont think sr ecu's have a diagnostic function. not sure but i never seen anyother sr cars have a chech engine light.

turboex
08-03-2003, 08:15 PM
good point, i have never realy heard anyone ask about engine codes on an ecu, so maybe the dont have a mil light. Hum..

DudeYourSoOOJDM
08-04-2003, 01:49 AM
There is no CEL for SR......run the codes off of the ECU.

turboex
08-04-2003, 04:30 AM
hum how do i do this?

PAnut240
08-04-2003, 08:07 AM
I would say do a search. I know this has been covered on this page before. If you can't find it Search Google, and you should be able to find the code page for sr's. If I had mine with me I would give the site to you. I'll check later.
Jim

old_s13
08-04-2003, 08:51 AM
"check engine" is a light mostly for emissions. sure, you can get other error codes off of the ECU but in US cars, the concept of check-engine has always been to scare customers into running back to the dealership thinking their car needs serious work, when its really just EGR or something silly.

Check engine = crap. Pop your hood, check to see your motor is still ther = done. Congratulations, you checked your motor.

- Mike

rednerd
08-06-2003, 08:57 PM
For anyone who cares , a Snap-On Mt2500 scan tool works with the SR computer. I don't know about diagnostics, but it will pull, and clear codes. The monitor function also works. Just make sure you have the wires that connect the engine harness to the body harness wired properly.

Ohh, I use a 1993 DOHC 240sx vin on the scan tool.

Jon