PDA

View Full Version : Need some S14 SR20DET help!!!!!!

Steve Lloyd
08-10-2010, 07:15 PM
:rl::fruit::smash:
JDMwannaBE
08-10-2010, 07:48 PM
all your fuses/relays good? have you gone through the new wiring you did? did you do any soldering? if so you may have a bad ground from it. i've had that happen before. just some suggestions.
Sam_Well.13
08-10-2010, 08:19 PM
staring at your avatar got me blanked out. sorry im no help =/ lol

nice boobs on that chick though.
Steve Lloyd
08-10-2010, 08:40 PM
all your fuses/relays good? have you gone through the new wiring you did? did you do any soldering? if so you may have a bad ground from it. i've had that happen before. just some suggestions.


The only soldering I did was on the MAF signal and ground wire. The relays work if I manually ground the wires that the ECU should be grounding, all the grounds seem to be fine, power gets to the ECU, it's just the 2 wires that are supposed to switch to ground from the ECU to trigger the relays aren't switching over anymore.
Slidin' Sam
08-10-2010, 09:24 PM
Try disconnecting your battery, then unplugging your ECU. Wait a minute, then plug the ECU back in, then hook up the batter again. Then try to start it and see what happens. Sometimes the ECU just needs to be reset. Make sure all your connectors are good and tight too!
JDMwannaBE
08-10-2010, 09:43 PM
Try disconnecting your battery, then unplugging your ECU. Wait a minute, then plug the ECU back in, then hook up the batter again. Then try to start it and see what happens. Sometimes the ECU just needs to be reset. Make sure all your connectors are good and tight too!
True statement