Camber arm bolt is too short help please

[240sx1234]

I bought a Godspeed rear upper control arm to control the camber from my lowered 95 240sx.I bought it from another member on the forum and I didn't get any bolts with it.I read it's suppose to come with ones for the side closer to the wheel but to use the stock for the inside.the stock bolt goes through the u-shaped part but barely fits in to the nut.am i suppose to tighten to where the u shapes part bends?or go to Home depot/lowes and get a longer bought to fit through there?


I apologize for being such a "noob" at this but I'm trying to learn

[Wabash9000]

home depot typically doesn't sell bolts strong enough for automotive applications. I'd say just tighten it down, my godspeed arms the end is a little bit angled out so when I put it on I will probably have to do the same.

[240sx1234]

Ya is it supposed to be bent like that?or does it straighten as you tighten it?Can it even bend?