PDA

View Full Version : LAWL WTF- S14 SR hates me

DriftVader
07-17-2010, 07:05 PM
YouTube - IMG_0241.MOV (http://www.youtube.com/watch?v=7ddwk9Qt2KM)

This is my video of what my car is doing to me! I am almost bald now due to the pulling of the hair this car is making me do!. Help please guys. :barfkiss:
jamanrr
07-17-2010, 08:04 PM
YouTube - IMG_0241.MOV (http://www.youtube.com/watch?v=7ddwk9Qt2KM)

This is my video of what my car is doing to me! I am almost bald now due to the pulling of the hair this car is making me do!. Help please guys. :barfkiss:


Why do you have your fuse relays on the drivers side wheel well? I am in Arkansas as well. You have this car at a shop?
DriftVader
07-17-2010, 08:15 PM
I built this car in my car port on Little rock AFB lol. The reason the fuse box is on the driver side is cause im using all orginal JDM harneses. NOT cause im a JDM freak, but cause thats what was in my car in Japan. I got alot of fixing up on the mess in the engine bay i know lol.
h22ek
07-17-2010, 08:16 PM
bad maf, adjust your tps to fsm specs, check your ecu for any codes
jamanrr
07-17-2010, 08:28 PM
I built this car in my car port on Little rock AFB lol. The reason the fuse box is on the driver side is cause im using all orginal JDM harneses. NOT cause im a JDM freak, but cause thats what was in my car in Japan. I got alot of fixing up on the mess in the engine bay i know lol.


yeah wiring in general scares me which is why I had mine done by wiring specialties. Yeah like has been said check the maf or tps.
DriftVader
07-17-2010, 08:42 PM
TPS? whats that stand for? and what can i use to check codes?
jamanrr
07-17-2010, 08:56 PM
TPS? whats that stand for? and what can i use to check codes?

throttle position sensor. It is on the throttle body. You have to get the ecu into learning mode to check codes. It looks like you have an s14a sr20det ecu and if that is the case get a factory service manual off the internet. They are free and make life a lot easier. It would be a little big to email it to you. You have to take a small screw driver and turn it like counter clock wise and then clock wise to get it into mode. Then again I think you may have to use the consult port but I can not remember -- I use an Apexi Power FC