kwin507
07-10-2010, 03:10 PM
Name: Kenny
Location: Richmond
Contact: PM, [email protected], 804 822 2305
Price: lets say i put over 15k TRADE!
DD
Here im looking to trade my 92 s13 coupe se model with an Rb25det series II.
I want something different , my plan was to fully restore this whole car in and out, but i cant afford a 2nd car with ft work school and family issues . Anyone who can give me a nice dd id def take a look . so throw me some offers
Engine/Trans: wiring service done by JE import performace (Maryland)
Rb25det series II (JEI)
Godspeed FMIC one sided (ebay)
New starter (RAW Brokerage)
New Nissan Quest Alternator upgrade (AI)
ISIS dual core radiator (Raw Brokerage)
Dual Slim Fans (AAP) one big pusher and a little puller
Samco Sport Radiator Hoses (FRsport)
Circuit Sport Aluminum Overflow tank (FRsport)
JGY mounts (JGY)
Straight cut gears (JEI)
Spec Stage 3 Clutch Kit (FRsport)
DSS 1 piece steel driveshaft (Phase2motortrend)
300zx rear end
Custom exhaust 3inch to magnaflow 4 muffler all black and really QUIET
Walboro 255lph (Phase2motortrend)
Nismo Thermostat not installed (FRsport)
Exterior:
DMAx smoked taillights (FRsport)
17x9 et 35 wrapped with 215/45 needs spacers to fit on which i will include
18x9.5 et 35 wrapped with 245/45 rears are on
wheels need to be re-polished but its not bad sand polish clear done!
Fortune Auto 500 series basically brand new less than 3 months (Billy @ Import Image)
Interior:
Custom Auto Meter Carbon fiber series gauge cluster fuel, both speedo and tach need to be wired, volt, boost , oil pressure not installed
STRi Turbo not installed (Phase2motortrend)
the good: car runs everyday for the past year and a half and still going. has p/s all power options windows and sunroof
BRAND NEW inspection 6/11
the bad: needs some a little tlc and itll be perfect.
no ac.
needs new outer tie rods (done)
tension rods (done)
alignment
recent power steering leak from pressure hose so you just need a new one KA p-hose is fine . fluid last about a week
body is in fairly good condition. right fender isnt too good and left is okay. front bumper needs a clear coat and last the hood has a few high spots( i planned on a silvia front so i dont care)
paint wasnt painted right from whoever the last owner was because they paint right over the damn red wtf? im a mechanic as well as body and paint so if youd like id repaint.
underneath jackass's jacked up , so its pushed in but just tear the carpet out and knock it down til perfect
story of the car:
so i picked up this car after i wrecked my last car. vehicle used to have a rb20det(r32). so i had to do some work and fix major issues whoever built it the first time.
i went ahead and sold the motor and the shitty wiring it came with. I bought the motor from jei up north rb25det(r33) series II and threw it in. this car had a lot of time and money put into this to make it half way done. i have receipts for all work done and have plenty and plenty of people to vouch for this.
the car is well maintain and i have plenty of people who will vouch. im a mechanic and im not letting my dd take a dump on me
here is my build on zilvia and a lot more pictures
http://zilvia.net/f/mid-atlantic-states/264786-1992-s13-coupe-swap-poop-rb20det-_____.html
http://i62.photobucket.com/albums/h94/ric3man507/th_005.jpg (http://s62.photobucket.com/albums/h94/ric3man507/?action=view¤t=005.mp4)
http://i62.photobucket.com/albums/h94/ric3man507/28388_451233123451_607903451_589731.jpg
Location: Richmond
Contact: PM, [email protected], 804 822 2305
Price: lets say i put over 15k TRADE!
DD
Here im looking to trade my 92 s13 coupe se model with an Rb25det series II.
I want something different , my plan was to fully restore this whole car in and out, but i cant afford a 2nd car with ft work school and family issues . Anyone who can give me a nice dd id def take a look . so throw me some offers
Engine/Trans: wiring service done by JE import performace (Maryland)
Rb25det series II (JEI)
Godspeed FMIC one sided (ebay)
New starter (RAW Brokerage)
New Nissan Quest Alternator upgrade (AI)
ISIS dual core radiator (Raw Brokerage)
Dual Slim Fans (AAP) one big pusher and a little puller
Samco Sport Radiator Hoses (FRsport)
Circuit Sport Aluminum Overflow tank (FRsport)
JGY mounts (JGY)
Straight cut gears (JEI)
Spec Stage 3 Clutch Kit (FRsport)
DSS 1 piece steel driveshaft (Phase2motortrend)
300zx rear end
Custom exhaust 3inch to magnaflow 4 muffler all black and really QUIET
Walboro 255lph (Phase2motortrend)
Nismo Thermostat not installed (FRsport)
Exterior:
DMAx smoked taillights (FRsport)
17x9 et 35 wrapped with 215/45 needs spacers to fit on which i will include
18x9.5 et 35 wrapped with 245/45 rears are on
wheels need to be re-polished but its not bad sand polish clear done!
Fortune Auto 500 series basically brand new less than 3 months (Billy @ Import Image)
Interior:
Custom Auto Meter Carbon fiber series gauge cluster fuel, both speedo and tach need to be wired, volt, boost , oil pressure not installed
STRi Turbo not installed (Phase2motortrend)
the good: car runs everyday for the past year and a half and still going. has p/s all power options windows and sunroof
BRAND NEW inspection 6/11
the bad: needs some a little tlc and itll be perfect.
no ac.
needs new outer tie rods (done)
tension rods (done)
alignment
recent power steering leak from pressure hose so you just need a new one KA p-hose is fine . fluid last about a week
body is in fairly good condition. right fender isnt too good and left is okay. front bumper needs a clear coat and last the hood has a few high spots( i planned on a silvia front so i dont care)
paint wasnt painted right from whoever the last owner was because they paint right over the damn red wtf? im a mechanic as well as body and paint so if youd like id repaint.
underneath jackass's jacked up , so its pushed in but just tear the carpet out and knock it down til perfect
story of the car:
so i picked up this car after i wrecked my last car. vehicle used to have a rb20det(r32). so i had to do some work and fix major issues whoever built it the first time.
i went ahead and sold the motor and the shitty wiring it came with. I bought the motor from jei up north rb25det(r33) series II and threw it in. this car had a lot of time and money put into this to make it half way done. i have receipts for all work done and have plenty and plenty of people to vouch for this.
the car is well maintain and i have plenty of people who will vouch. im a mechanic and im not letting my dd take a dump on me
here is my build on zilvia and a lot more pictures
http://zilvia.net/f/mid-atlantic-states/264786-1992-s13-coupe-swap-poop-rb20det-_____.html
http://i62.photobucket.com/albums/h94/ric3man507/th_005.jpg (http://s62.photobucket.com/albums/h94/ric3man507/?action=view¤t=005.mp4)
http://i62.photobucket.com/albums/h94/ric3man507/28388_451233123451_607903451_589731.jpg