View Full Version : 95 ka24de in s13.(wont run)
240killer
03-12-2010, 09:51 PM
I have swapped a 95' KA24DE into my 92' which was a KA24DE. I put all S13 intake mani and everything on it, however only ran with the MAF un-plugged. I tried changing the sensors on the intake mani to insure they were S13 sensors, now it will not start at all. If you have any information or could help out with anything, please let me know. (Car hasn't ran in 2 years).
Thanks.
check spark & fuel and timing. You said it ran with out the maf. Try resetting ecu .
240killer
03-13-2010, 12:16 PM
im pretty sure i have done all of those.
jdm213
03-13-2010, 11:33 PM
did you use the s13 distributor instead of the s14"s?
240killer
03-14-2010, 01:59 PM
yes, i used the S13 distributor
R G: maybe i havent reset the ecu. im not sure. its been so long.
headsup
03-14-2010, 02:58 PM
So which one are you missing ? is it spark , air or fuel?
240killer
03-15-2010, 05:31 PM
i have it all. im pretty sure
tr4c3
03-15-2010, 05:41 PM
My brother swapped a 95 ka into his sohc hatch and had a starting issue as well. Ended up being his harness. He swapped it out and the car ran fine.
fos240
03-15-2010, 08:32 PM
distributor is probably off. try resetting it. also use starter fluid to help you out.
frankie
TrIpLe "D"
03-15-2010, 09:16 PM
drop the distributor in at 20 deg tdc, not zero
headsup
03-16-2010, 06:49 PM
You should recheck everything if you had spark fuel and air it should start unless your timing is off , or maybe bad gas you did say it sat for two years!
240killer
03-17-2010, 12:44 PM
i have put new gas in it. i dont even know. i have done pretty much everything i have read on other theads on the site. i really wanna just call someone that knows what the hell there doing but i dont think anyone on this site lives close by so ill hav to find someone on another site that i am on.
keep trying to help me out. please!!!!!!!!!!!!!
get a note book and log everything you have done. Re-check everything. Make sure you have good grounds. Do not use shitty autozone or napa ground kits.
BMXer91331
03-18-2010, 08:13 AM
i have a KA problem too. so as any 95' S14 owner knows its a B to get engine parts since the S13 KA-de is a little different as the 95. then in 96 they decided to change that shi* again, to obd2. so all in all i have a 95 s14 that needs an engine, what would be needed to make an s13 ka-de work on an s14? or can i just swap all the parts to my block and make it work? i need a head and i know a few things are diferent such as the distributor wires 5 on the s13 as oposed to 4 on the s14. so whats my best bet? keep and make an s13 ka work on my s14 or get an s13 engine and put the parts on my motor. will the head work if i change my intake manifold (since its different) onto it and my distributor? and do i need to change the harness? maybe me and the guy posting this thred should swap engines haha
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.