PDA

View Full Version : need help transmission isnt coming out!! plz help!

zachariah
12-11-2009, 02:07 PM
i have an rb25 im am trying to remove the tranny to replace the clutch i have all the bolts taken out of the tranny, but when i go to try and take it out it seems like it kinda springs back into place and wont come out i dont know if there is a trick that i dont know or what i never taken one out if you guys could help me that would be great thanks in advance any help is much appreciated!!
burninskulls0911
12-11-2009, 02:12 PM
is it in an s-chassis?
is it hitting the firewall when you pull it back
codyace
12-11-2009, 03:12 PM
Got all the bolts out?

Before removing the slave cylinder, push on the cluch pedal...sometimes this helps push stubborn transmissions back a bit back.
zachariah
12-11-2009, 06:12 PM
Got all the bolts out?

Before removing the slave cylinder, push on the cluch pedal...sometimes this helps push stubborn transmissions back a bit back.

yeah im postive there all there all out il give that a try.
Ceepo
12-11-2009, 10:20 PM
what car is this in? odds are your hitting the firewall...
Zacho
12-12-2009, 12:12 AM
Starter removed all the way?

Slave disconnected?

disconnected clips for sensors?

I had to rotate my transmission to allow me to pull it off. The starter bump in the bellhousing wouldn't clear the tunnel. Rotate = solved.
zachariah
12-12-2009, 12:44 PM
what car is this in? odds are your hitting the firewall...

its in a R33 skyline and im prety sure its not hitting cus i can see up there
zachariah
12-12-2009, 12:52 PM
Starter removed all the way?

Slave disconnected?

disconnected clips for sensors?

I had to rotate my transmission to allow me to pull it off. The starter bump in the bellhousing wouldn't clear the tunnel. Rotate = solved.

does the starter have to be removed? its a r33 skyline and its not hitting anything.
Ceepo
12-12-2009, 01:35 PM
When we pulled the motor in my freind r33(we did 5 of them) we dropped the whole front subframe and motor lol... but it was a pita... everything is disconnected right, drive shaft, tranny mount, all the bolts, i would take the starter off to i think the bolts that hold it on are also used to bolt the trans/motor together, clutch slave/lines, i you may have to tilt the motor back a little to get the trans to come out...