KA-T Down pipe

[Flash_RPS13]

do i need to customize my own downpipe for a t25 setup on a s14 ka24
or where can i get a KA 3in down pipe???

[Biggamehit]

Most who run the t25/28 bottom mount can run an SR downpipe from the dump with no issue. I cant say I know anyone with a Ka24-e setup though. KA manifolds have been made with T2 flanges for sometime now. Most of the KA24e manifolds I have seen in person are T3 flanged.

I had to make my own downpipe using two 180 deg bends and a V-band flange.

Short of going with a KA-T mass produced kit...... no KA-T is the same so there is no downpipe that you can just go and pick up


what mine looked like after I got done.

http://img177.imageshack.us/img177/2845/kpicture008ns5.jpg

http://img99.imageshack.us/img99/8976/kpicture010zt1.jpg

http://img258.imageshack.us/img258/2955/hpim0289gh0.jpg

http://img442.imageshack.us/img442/1228/p1010131ka6.jpg

http://img90.imageshack.us/img90/881/p1010130ih0.jpg


I did the turbo upgrade, jgs tools manifold kit and downpipe all in one day... so it doesn't take a lot of time if you have your own welders or access to a buddy or something. If I had done it over.. which I will when I go back state side. Ill slice it in have and divorce the pipe. Its Long as hell and I have to do a handstand to remove it.

[Flash_RPS13]

Hmm ok i see
thanks alot for your time

[Biggamehit]

no problem bro.. info is always at the tip of my finger via bookmarks lol.