jing
09-19-2009, 12:20 AM
I have a custom IC setup and the other day I got a flange welded onto the hot pipe for my SSQV. This required my hot pipe to be removed and re-installed.
Once I got my BOV installed, I went for a drive. The BOV worked just fine... until when boosting this one time, I heard a loud "crack" type of sound, like metal hitting metal, so I pulled over right away and popped the hood. To my surprise, I saw that the upper portion of my hot pipe had separated itself from the clamp, so I passed it off as the installer at the shop I went to not tightening it properly, and so I tightened it and went on my way.
A few more boosts here and there, and "crack" popped out my hot pipe yet again. Once again, I put the hot pipe back in place and tightened the clamp and have since been careful as to how much I boost. I noticed that in both situations, my pipe popping out of place happened when I boosted anything over 7psi.
Any suggestions as to what the problem is? This never happened until my BOV was installed..
Once I got my BOV installed, I went for a drive. The BOV worked just fine... until when boosting this one time, I heard a loud "crack" type of sound, like metal hitting metal, so I pulled over right away and popped the hood. To my surprise, I saw that the upper portion of my hot pipe had separated itself from the clamp, so I passed it off as the installer at the shop I went to not tightening it properly, and so I tightened it and went on my way.
A few more boosts here and there, and "crack" popped out my hot pipe yet again. Once again, I put the hot pipe back in place and tightened the clamp and have since been careful as to how much I boost. I noticed that in both situations, my pipe popping out of place happened when I boosted anything over 7psi.
Any suggestions as to what the problem is? This never happened until my BOV was installed..