Z32 Maf

[Maeda]

I think i wired this thing correctly.... so does anyone have any idea why my car will start and then proceed to die... i think its too rich... i can keep the motor going if i put my foot on the gas and keep the rev above 1500 or so... any ideas?

edit: oh and im using e-manage to work with the Z32 maf... so it should scale the fuel table accordingly i think(?)

[boosteds14]

is your motor forced induced?

what is the voltage you are getting at idle?
have you put in bigger injectors because you are using a z32 MAF?

[Maeda]

i was thinking i could get the maf to work NA, then add my injectors and get those to work NA before i slapped my turbo on...

a step by step build up?

will the maf not work like this? i was under the impression that as long as emanage knew it was a z32 maf it would work

[boosteds14]

hmmm, now you got me stumped.

it should work if you set the emanage up correctly to correspond with the z32 MAF.

did you wire it up wrong maybe? thats a common stupid mistake with electrical.

all call AEM can try to get some info from them. this is ****ing me off that i need to know too.

ill get back to you when i get some info.

[Maeda]

i wired it up good because im getting rpm signal and my cars NOT in safe mode with the stock maf...

i set it up for HW2 which is the z32 maf... and it should work just like that right? i dont need to touch anything else?

im still puzzled :confused: :confused: :confused: