SR wont fire. Help please

[SmokeCRX]

Hey guys I'm a noob to the Nissan world and I need some help. I just installed the s13 SR20det blacktop motor and Wired everything up according to the FRsport write up. My engine cranks but I have no spark or injector pulse. How do I check my igniter? Anytime the key is on I have 12V at all 4 wires on the 4 wire connector. When cranking I have a pulse of about .2V at all the colored wires in the 5 wire connector. What is it I'm doin wrong? Please help Thanks

[slider2828]

Take out the spark plug and coilpack. Ground the spark plug with coilpack attached and check for spark. If you have spark, then you are fine. Remember to remove the fuel pump fuse.... I am sure you can smell the gas by now if you have it. Is your fuel pump turning on? If you have fuel and spark, then most likely you need to do the timing with the Cam Angle Sensor, if you dunno what is that.... FSM or search....

Search and you will find all information.

[SmokeCRX]

I pulled the coil...I have no spark. And I checked for inj pulse with a noid light...no pulse. How do I check the Igniter?

[SmokeCRX]

Also...the check engine light is not coming on when the ignition is turned on? Anybody know why that could be?

[shortie180sx]

Also...the check engine light is not coming on when the ignition is turned on? Anybody know why that could be?


how are the wiring and fuses?
or maybe someone took out/smashed the CEL bulb... easiest way to never get anymore CEL's :)

[midnight_rex]

sounds like the wiring might be wrong.

[slider2828]

Definitely wiring or ECU is dead.... check your wiring again and check all your grounds.

[besTint]

was the car a automatic before the swap?

[godsmack]

did you ground the ecu?

[Projectenzo]

you check the continuity of the igniter by pluging up the side recieving power and put your leads to the opn side.