PDA

View Full Version : Bee*R Powerbuilder install help !!


Drft_S14
05-28-2009, 09:59 PM
Hi, just wondering if any of you have had the same problem, I installed the bee*r followed the diagrams as written, i have an S14 sr20det, into a kouki 98, seems like the bee*r is working, if revs are set @ 1 the light starts flashing as if it was limiting the revs, but its not. It seems like its not cutting the ignition like its suppose to. Any suggestions would help ! thank you in advance.

Gription
05-29-2009, 08:14 AM
Mine was doing that after I installed it. I knew I wired it correctly but I couldn't figure out what was wrong. Turned out the unit was broken (I bought it used), which I realized after I bought another one and it worked.

Drft_S14
05-29-2009, 09:05 PM
bought mine brand new from rhdjapan.com, i was wondering maybe they gave me the type-h, which is suppose to go onto hondas....

DrftKingIII
10-16-2009, 11:48 PM
Bump. I have this now and am having the same problems on a 97 with a RB20DET. The car starts up fine, and revs fine and the light comes on and blinks as if it should be cutting ignition but it does not.

Im hoping its not a dead unit, but any other advise would be very helpful.

Mike

ATLspeed
10-17-2009, 11:37 AM
biggamehit.teammnr.com (http://biggamehit.teammnr.com/)

DrftKingIII
10-17-2009, 06:46 PM
biggamehit.teammnr.com (http://biggamehit.teammnr.com/)
That write up is for a OBDI KA. And its just an install. I wired it in properly....Im thinking the unit itself is messed up.