PDA

View Full Version : S14 Kouki vs. S14 Zenki Question

97nismo
05-10-2009, 08:59 PM
I notice a few people sell what seems to be an underneath cooling panel or skidplate from there s14 kouki from time to time. I never bought one but was wondering. Is there a difference in the zenki one??? Or does it really matter, because I am in the middle of a JDM kouki conversion myself.
Maiku240sxS14
05-10-2009, 09:17 PM
I can't say for sure, but I just bought a Parts By Max Skid Plate for my Zenki. I didn't need to specify if I had a S14 Zenki or Kouki....hope this helps.
garagelu
05-10-2009, 09:44 PM
zenki and kouki are the same. The only difference is the forward wheel well plastic is different. If you have a front mount, you may have to do some cutting on that plastic undertray.
khilgers
05-10-2009, 09:49 PM
if you need a skid plate, just make your own. This cost me $14 and took about 2 hours to make. Only tools were a tape measure, marker, file, and a cut off wheel for my angle grinder.

http://www.khilgers.com/forumpics/240swap/163.jpg
grnappletree14
05-11-2009, 12:45 AM
if you need a skid plate, just make your own. This cost me $14 and took about 2 hours to make. Only tools were a tape measure, marker, file, and a cut off wheel for my angle grinder.

http://www.khilgers.com/forumpics/240swap/163.jpg

where did u buy the sheet metal at for that low.... also did u write down the measurements by any chance
97nismo
05-11-2009, 07:40 AM
zenki and kouki are the same. The only difference is the forward wheel well plastic is different. If you have a front mount, you may have to do some cutting on that plastic undertray.

that what i thought, and no i do not have a front mount
captainfalco
05-11-2009, 09:23 AM
where did u buy the sheet metal at for that low.... also did u write down the measurements by any chance

No need for buying all of that sheetmetal. I'm going to make mine out of a road sign that came down near my house a while back (not an important one like a stop sign), and mount it with the reflective side down.
JVDSKYRINE
05-11-2009, 10:37 AM
No need for buying all of that sheetmetal. I'm going to make mine out of a road sign that came down near my house a while back (not an important one like a stop sign), and mount it with the reflective side down.


lol sweet idea i jacked a couple men at work signs when i was out on a drunken debauckle
upsdude
06-12-2010, 05:05 PM
lol i think it's time the stop sign by my house mysteriously comes loose.
iamtheyi
06-12-2010, 06:15 PM
damnnn you guys are ghettooo~
!Zar!
06-12-2010, 06:21 PM
You bumped an old ass thread just to say you want to do something illegal?

Come on people!
JDM Sil4ty
06-12-2010, 11:32 PM
yeah ouch. good idea, but bad place to post it.