PDA

View Full Version : Help Car Wire Harness

surge s14
05-09-2009, 06:25 PM
i pulled out my wiring harness a few months ago to fix some rust holes and i cant remember were everything flowed

i had pictures for back up and i lost them

dose anyone have any pictures that can help me out?
MrFairlady
05-09-2009, 07:40 PM
Which harness,..Engine harness,..Chassis Harness,..Interior Body Harness?

I did the same but I Masking taped and #'d everything that matched up.
The Harness I used was even a 93 SE coupe harness that I used in my 90 hatch I've been working and (and will be till 2022 w/ all my leaks spring up)

Just gotta Figure that every harness plug is diff so It can only really go 1 place.1sr off gotta Find all the little Knick Knacks you Pulled out and match up from there.THE CAR PROB dosen't need half of them.
I just need to know which one your speaking of?
surge s14
05-09-2009, 08:08 PM
Interior Body Harness

under dash to the back of the car

i wish i would have thought of marking everything haha
surge s14
05-10-2009, 11:23 AM
tttt.............
BoostedAuto
05-10-2009, 03:08 PM
im on the same boat with you, only with then engine bay harness and 1 connector that goes through the firewall on the pass side...Its a white connector, anyone please Im going nuts!!!
Mister.E
05-10-2009, 05:09 PM
Interior Body Harness

under dash to the back of the car

i wish i would have thought of marking everything haha

it only travels down one side of the car (drivers side here in japan). if i was you id recommend tucking it as well as you can when you are putting it back. damn near all of the connectors were cut to length from the factory and really only could go to one spot. this is one of those things you are just gonna have to jump in and do. once you start you will realize that it really isnt that difficult.
Rayne
05-10-2009, 05:29 PM
it only travels down one side of the car (drivers side here in japan). if i was you id recommend tucking it as well as you can when you are putting it back. damn near all of the connectors were cut to length from the factory and really only could go to one spot. this is one of those things you are just gonna have to jump in and do. once you start you will realize that it really isnt that difficult.

Same here in the states.

The FSM for the specific model car will help out a lot.
surge s14
05-14-2009, 12:04 AM
i found what i was looking for hopefully this will help someone
http://i164.photobucket.com/albums/u17/surges14/Bullshit/harnesslayout.jpg

http://i164.photobucket.com/albums/u17/surges14/Bullshit/Clipboard07.jpg

http://i164.photobucket.com/albums/u17/surges14/Bullshit/harnesslayout.jpg