PDA

View Full Version : Is there an easy way of putting Fluid in a MT?


LoCo
03-26-2003, 04:49 PM
I tried putting Mobile 1 Fluid... comes in a squeeze bottle...

but damn there is no room to fit it I probably wasted more than 1/2 of it trying to put it in!

What should I do for it? the room between the bottom header/cat and tranny is pretty small. Any suggestions? :confused:

Dousan_PG
03-26-2003, 04:51 PM
ZOIKS!!
yo yo yo yo check it out yo

you need to get a pump!
hook it up to the bottle, then pump it in. its a REALLY easy job.

get a good pump! you will use the same one for the diff too! :)

u can get pumps at your local auto store. shouldnt cost more then 20 buckaroos

LoCo
03-26-2003, 05:03 PM
Originally posted by dousan36
ZOIKS!!
yo yo yo yo check it out yo

you need to get a pump!
hook it up to the bottle, then pump it in. its a REALLY easy job.

get a good pump! you will use the same one for the diff too! :)

u can get pumps at your local auto store. shouldnt cost more then 20 buckaroos

aiiiiiight check it... ima need a pump so i can pump my ish in... st8 up jigga-fied!

LoL

Thanks alot... gonna go by one now ;)

veilsideS14
03-26-2003, 06:01 PM
Or you can take the top fill plug off the transmission dump the fluid down the shifter hole till it starts to **** out the fill hole.

http://24.163.136.155/03232003/image009.jpg


EDIT: Wow...you can't say P.I.S.S. on this board? My virgin ears will bleed for Gawd sakes!

thelinja
03-26-2003, 06:07 PM
I went to Home Depot and got a funnel and about 2ft of 1in thick vinyl tubing to make a bong for the tranny. It worked well and only took about five minutes to fill.

syco3d
03-26-2003, 07:52 PM
For the record...where is the fill hole?

(ie. I don't really know) ...but then I haven't looked. Just want to make sure I know b4 I go try to change mine.

EIDT:Also...is there a drain plug around or do you have to "draw" the oil out of the fill hole?