s13pignose
02-28-2009, 04:52 PM
Hey on another subject my new nissan distributor cap and ign. rotor came in this morning, so I put em on shortly after. Everything went smooth but I noticed some differences between the old and new rotor. The new one had like this thin layer of black epoxy looking stuff on the tip of the conductor..I mean the top metal part of the rotor. The old one didn't. I thought it was some sorta protective tape or something at first, so I tried gently prying edge up on the bottom. Didn't peel up and infact a piece of it flaked off about the size of a grain of salt (no biggie), so I assumed it was there on purpose and for good and left well alone.
Car started and drove fine..and I pulled each plug wire to make sure all plugs fired. Also do any of you pack the wire terminals on the top of the cap for moisture? I skipped on that..since i don't plan to spray under the hood any time soon.
thanks
Car started and drove fine..and I pulled each plug wire to make sure all plugs fired. Also do any of you pack the wire terminals on the top of the cap for moisture? I skipped on that..since i don't plan to spray under the hood any time soon.
thanks