Stance Camber plate question

[Mr.J]

Has anyone had any difficulty threading the hex bolts on the camber plate in either of the two inner holes? I tried to do this only to find that the bolts bottom out on a circular metal plate attached to the underside. You can see from the photo were the metal plate interfers.

Also, does anyone know if the spherical bearings are replaceable?

Thanks

[SoSideways]

I have not had any problems with my camber plates from Stance, ever.

[codunc]

that looks like it might be defective. im pretty sure the hole should go all the way through. two of mine are in the inner holes and they didn't bottom out.
i would give them a call about that and they can probably answer your question on the pillow ball replacement too

[SoSideways]

I looked on mine last night and mine don't have that extra plate there.

Your's shouldn't look like that.

[Mr.J]

Perhaps mine is a newer design (but, seemingly not better). I'm sure that if I pick up some shorter cap screws I would solve the problem, but I have a problem with that on principal, because you shouldn't have to replace pieces on new product due to the manufacturers lack of attention to detail. I will email Stance and see what they say.