injectors not firing!!!

[fuxsyou13]

so I put a 95' ka in my 93' hatch, and painted the engine bay while I was at it. I replaced the old engine cause it overheated. swaped all emission stuff. everything hooked up, I go to start it, it cranks but no cigar... All grounds are hooked up, I finally find out my injectors are NOT RECEIVING ANY POWER!!!.... swaped ecu, maf, and still nothing. can anyone with any insight please shed some light on my dark situation. thanx..... :werd::werd:

[s13boy89]

have you checked your grounds that was my problem

[fuxsyou13]

grounds are all hooked up to the best of my knowledge... I even sanded around the little hole to expose the bare metal...

[CrazyKoukiS14]

are the injectors not getting power? or fuel?

[jspeedm]

possible cam sensor

[SoguRacing]

check the pin at the ecu for ground. injectors are ground control.

[fuxsyou13]

-injectors have no power, I checked with diodes...
-How can I check my cam sensor?... is that expensive or hard to replace?
-I have a volt meter, can I use that to check the ecu pin?
Not really familiar with electrical, I always tried avoiding it but, is inevitable...
...thanx for the advice...