HKS Cams and Valve Springs Install Quesitons

[Beazle]

Installing Cams and Valve springs today. I've got the snap on tool and compression tester hooked up to air compressor to keep the valve from falling down. Any tips or anything I should look out for? Thanks.

[240sxspeed]

yeah the keepers on the exhaust side will b a pain in the ass cuz of the heat they take so tap them with a hammer or something so u can loosen then up a bit also stuff some rags in the the oil passages cuz they r huge and u will drop a keeper in there if your not careful so basically make sure the air pressure stays up and u wont lose a valve u know good luck

[Geno750]

Buy valve seals and do them at the same time. Might as well since you'll have everything apart anyway.