big problem

[n240sxfnatic]

So whe I was installing my arp head studs I dropped a washer on the last stud on the back of the head on the exhaust side. Heres the problem, its nowhere to be found. I know is back there somewhere bc I was digging for it with a wire and felt it but now it is nowhere. Ive been digging for it for a hour and am beyond pissed. The motor is an s13 sr if that matters. Anyone had this happen before? What should I do?

[s13boy89]

pull it apart if not by by engine

[n240sxfnatic]

Im obviously not gonna leave it in there, im not retarded

[MELLO*SOS]

try a magnet to fish it out? GL, that sucks.

[Killa_D]

i say take the head out and make sure you get it out then put it back again

[n240sxfnatic]

YESSSSSSS I got it it was in the very back and pushed to one side so i had to fish for it with a small but powerful magnet for about 15 mins but i got it

[240sxdrifterS14]

congrats!!! lol

[Master Chief]

Next time, use compressed air to the area you suspect it is in - it will blow it right off.
On the back of the head, there isnt a hole big enough to drop an ARP washer thru it, as far as i remeber.