View Full Version : SR rebuild... blowing assload of oil through VC?
babowc
06-26-2008, 04:39 PM
So.. I'm getting a motor with a shitload of blowby through the VC breather..
I've rebuilt a KA before, but not a SR and I'm sure it's same principles, but what could that possibly be?
I'm not too familiar with SR, so I don't know what it can be..
off the top of my head:
rings?
valve seals?
owner said the oil was clean and free from metals and the block is in one peice..lol
lmk guys
statik
06-26-2008, 04:49 PM
grand canyon ring gap?
babowc
06-26-2008, 04:51 PM
lol
i guess it's a simple fix, no?
statik
06-26-2008, 04:55 PM
check your compression and do a leakdown test. If it's the rings, you're going to need to tear it down and get new rings and gap them properly.
babowc
06-26-2008, 07:59 PM
thankkss!
I just went and picked it up..
ill see what it is :)
BustedS13
06-26-2008, 09:42 PM
i was blowing a ton of smoke after putting my KA back in. i forgot to drain the oil.
and then i put in a refill. so it had two gallons of oil in it.
....did you put 2 gallons of oil in your engine
sr20boostn20
06-26-2008, 09:56 PM
definatly sounds like some serious blow by.
bottom end rebuild asap.
total seal rings are garbage, dont use them.
drifxtfx1
06-26-2008, 09:59 PM
mine had a cracked piston, so look for that or rings and seals
slider2828
06-26-2008, 10:01 PM
Yes do leak down test, check your motor oil level, replace pcv valve, if KAT did you check whether if you have a restrictor on your turbo. Good luck..
babowc
06-26-2008, 11:21 PM
na
i just bought a motor.
ill check whats up.. more than likely a p-ring
ill start teardown after i get my ka-t finished :)
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.