View Full Version : WTB new rb25det trans clutch slave cylinder
Full-Lock
06-09-2008, 09:56 PM
anyone got one?
interchangeable with any other nissans?
i need the 2 bolt holes under the cylinder side by side
only clutch slave cylinders i can find are the ones that have a bolt hole on top, then actual cylinder, then another bolt hold on the bottom.
thansk!!
SleeperSx
06-10-2008, 08:02 AM
NAPA Part # 37487
Only 16$ I think total, Works Perfect, I run this slave on a Twin plate Cusco Exedy clutch, So you should not have any problems.
When you get the slave you will have to Drill the 2 bolt holes out to a accept a bigger bolt. But that takes 5 mins LOL.
SleeperSx
06-10-2008, 08:14 AM
http://i235.photobucket.com/albums/ee40/rb25drag/0213082029.jpg
This is the difference.
Full-Lock
06-10-2008, 09:10 AM
thanks a lot. ill be doing this today.
i take it the one on the right is the new slave from napa?
after i drill out the holes a bit everything lines up on the housing then? the mounting holes on the napa slave look further apart.
SleeperSx
06-11-2008, 05:50 AM
Ya the one on the right is the Napa slave. Everything lined right up on mine. Just don't tighten the slave down too hard or you will bust the ears off it. I already done 1 like that. But its a simple swap.
Full-Lock
06-11-2008, 10:34 AM
yea alright cool. ordered it yesterday since it was out o fstock at napa in town here. should be here today sometime
thanks again
SleeperSx
06-14-2008, 06:55 AM
no problem, any more questions just let me know.
imotion s14
06-14-2008, 11:39 AM
tsc tsc too late but for future reference..
http://www.nismoparts.com/catalog/?section=824#1726
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.