HUD/Dig Speedo gremlin and other Qs (PIC)

[02BRB20]

stock 92 KA24, HUD/digital speedo was not working initially, when I had a spark problem and my car wasnt cranking the HUD/dig. was operational. Got the car running again and the speedo and hud stopped working.

so the other day im pulling up into my driveway and I accidently love tap my parents old accord and my HUD and speedo turned back on, drove it around and it was fine but htis morning it was off again.

grounds are tight, any ideas?


andddddddddddddddddd should this be capped off?
http://i39.photobucket.com/albums/e157/VanishS14/asd007.jpg

[Flores240]

I got the same problem! I dont know what you could do to fix it, but i do know that for me i let the car warm up a bit and it will turn on. On cold day's it will never turn on unless i run the heater on for a couple of minutes. Really wish i knew what it was though, sorry i cant be much of a better help.

[koolcat]

Don't know if you are talking bout the speedo on the cluster or not but if your digital cluster speedo is not working the possible solution is to solder the board in the speedo side.

[xsparc]

sounds like the solder joints on the speed/hud are wearing out, add some flux, heat, and some solder if needed. you should be fine after that.

and that thing that needs to be capped is just the an AC port, doesnt NEED a cap, but its nice to keep dirt out.

[Sileighty_85]

http://www.zilvia.net/f/showthread.php?t=160159&highlight=HUD+Fix

[02BRB20]

^yeah I know about that thread and the ceramic board, did not want go through my whole dash if it was something in the engine bay.