EXTENDED studs

[die hardrift fan]

any brand is fine. preferably nismo.
need them to fit on my stock 4lug 91 240 hatch.
need these asap.
anyone knws where to get them cheap as hell
lemme knw

thanks!

[5t341tH]

http://www.optionsauto.com/
check em out. extended for 2 bucks each.
remember to order 13.5mm knurl

[die hardrift fan]

looking for a used set for cheap. looking for a local pickup around 626/ la area. willing to drive to pick them up. need these asap to put my rims on
gimme a price and ill pick em up

[hotlavaflow]

http://www.optionsauto.com/
check em out. extended for 2 bucks each.
remember to order 13.5mm knurl

Nice I was looking for some too. $2/each is pretty good. How's the quality of Ichiba lugs? I heard they're conversion hubs are "ok"

[die hardrift fan]

http://www.optionsauto.com/
check em out. extended for 2 bucks each.
remember to order 13.5mm knurl

i just checked that site today. i dont have spacers so will these fit on my stock hubs? i want to buy them asap but it says "for use on spacers only" and i will be using these on my stock hubs. i am gonna replace my stock studs with these.

http://www.optionsauto.com/prodinfo.asp?number=ICH-NS-122550S

lmk thanks ppl

[apex]

why do u need extened studs if u dont got spacers??

[die hardrift fan]

i got ghetto spacers that dnt have the studs on the spacers. lol

[5t341tH]

Nice I was looking for some too. $2/each is pretty good. How's the quality of Ichiba lugs? I heard they're conversion hubs are "ok"
the hubs are great. i had em for 2 years or so. the ext. studs are nice. kinda neochrome-ish :)

[hotlavaflow]

^^^That's what's up. Ordering today.

[satal95]

I have some brand new Nismo 60mm studs. Bought them but never used them my loss your gain $120 shipped

[hotlavaflow]

I don't normally take pics while I work (that's why these are cell phone pics) but I finally installed my new studs.

Stock stud vs Ichiba 50mm
http://img.photobucket.com/albums/v629/hotlavaflow/IMG00698.jpg

Pull the calipers off and here we have stock studs
http://img.photobucket.com/albums/v629/hotlavaflow/IMG00699.jpg

Some PB Blast and 5 taps with a heavy hammer and we have this
http://img.photobucket.com/albums/v629/hotlavaflow/IMG00700.jpg

Slip the new studs in and put the rotor back (I upgraded while I was at it)
http://img.photobucket.com/albums/v629/hotlavaflow/IMG00697.jpg

Throw on some washers ( I used a spacer as well)
http://img.photobucket.com/albums/v629/hotlavaflow/IMG00701.jpg

Now use a lug nut and tighten it which pulls the stud in place
http://img.photobucket.com/albums/v629/hotlavaflow/IMG00703.jpg

All four are tight. Put the caliper back on and apply the brake to hold the rotor then really get at them (I swapped pads while I was at it)
http://img.photobucket.com/albums/v629/hotlavaflow/IMG00696.jpg

Done and done
http://img.photobucket.com/albums/v629/hotlavaflow/IMG00705.jpg