Clutch Master Problems

[worr20]

Im doing a 5 speed swap and got a clutch master from napa. but the holes don't seem to match up with my clutch pedal. WTF? can someone help me out?

THanks

[racepar1]

It's probably the wrong one. :squint:

[Edcel]

if you can get a drill bit or a small flat head screw driver and make the holes bigger. same thing happened to me. hope fully youre talking about the holes where the bolt goes through to connect the master cylinder to the pedal right?

[agame001]

if they're far away from each other, then just adjust the length of the CMC by twisting the nut up or down the thread along with the end piece thing. make sure your pedal is at the very top position too. hope this works for ya.