Agency Power Boost controller

[SleepR 240sx]

I HAVE SEARCHED, SO DON'T FLAME I CAN'T FIND AN EXACT ANSWER.

Ok so i have the above mentioned controller, it is a bleed valve type. I just wanted to check that this setup was correct before installing....one end connects to a nipple on the piping behind the air filter, and the other end is tee'd into the vaccuum line going to the wastegate actuator. The arrow is pointing towards the actuator. Would that be correct. Any and all help is appreciated.

[louisdaboois]

basically you cut the vacuum line that goes from the intake manifold/compressor housing/ic piping/etc (anything with a boost source) the hose going to the actuator is plugged into the arrow nipple and the hose coming from the boost reference is plugged into the other nipple. youre just putting it in-line

[brndck]

um u fail at searching. took 2 seconds for me to find these
http://www.zilvia.net/f/showthread.php?t=106185&highlight=mbc+install
http://www.zilvia.net/f/showthread.php?t=116992&highlight=mbc+install

[SleepR 240sx]

Still a little confused...does the one side go to the nipple on my intake NOT my intercooler piping (don't have one)?

[aa87]

No, it goes on the intercooler piping, then to the wastegate. Get a nipple put on, welded or something

Stock sidemount has it on the big plastic hotpipe. My egay FMIC had to have one put on, i think they threaded in some kind of nipple it looks like, tapped the intercooler piping and wrapped it in teflon tape.