PDA

View Full Version : Parts Galore, I need some room!


240silvia
04-03-2008, 11:41 PM
Here's the list.....

I have Three DOHC Wiring Harnesses - $60 a piece

I have Two DOHC ECU's. Both are Autos so no speed cut - $30 a piece - BOTH ARE SOLD!!!!

One DOHC MAF - $20

N60 MAF with Cone Filter - $30

One SOHC MAF - $20

SR 3" Cold Pipe - $35 - SOLD!!!!

FULL DOHC Power Steering setup. Complete setup with the pump and resivoir - $150

I have a few DOHC gauge clusters - $40 a piece - TWO ARE SOLD!!!!

DOHC motor, about 115K, has a low knock, goes away above 2000 rpm, has intake and exhaust mani's with all sensors, water pump - $75

Driver and Passenger Front NON-ABS Calipers with lines and practically new pads - $50 for the set

2 - Stock KA Radiator - $80 a piece

Ebay Fuel Pressure Regulator $60 New - $30

I have about 4 clutch fans if anyone needs them - $10 a piece

Complete DOHC A/C system with pump - $150 - SOLD!!!!

Complete Cruise Control Setup - $60 I even have the Cruise Control Wheel if you want it

Stock S13 exhaust - $20

JDM 1/2 & 1/2 Pignose Signals, practically new - SOLD!!!!

2 complete sets of stock springs - $20 for a set of four

I have two rear hatches, rusted, but good glass - $20 a piece

5 speed swap parts: - $175 for all of it
-Trans
-Driveshaft
-Stock Shifter
-Stock Knob
-Resurfaced Flywheel

Automatic trans with about 100K, worked fine when removed. Needs reverse light o-ring seal replaced - $50

03-04 Kawakaki Ninja zx6-R, zx6-RR, and the 636 stock exhaust - $10

I have a few pics...

SOHC Throttle cable $15

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01946.jpg

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01945.jpg

HKS SSQV BOV flange - aluminum - $5

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01942.jpg

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01943.jpg

AEM UGEO Wideband face and silver trim - $5

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01940.jpg

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01939.jpg

N60 MAF with cone filter - $30

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01938.jpg

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01937.jpg

Steering wheels - $25 a piece Silvia Wheel $50 (top of wheel is kinda coming off)

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01934.jpg

Coils & ECU's

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01933.jpg

Gauge Clusters - $40 a piece

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01930.jpg

3" SR Cold side - $35

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01925.jpg

http://i90.photobucket.com/albums/k265/4cedKoop/stuff%20for%20sale/DSC01928.jpg

-Charles

Neejay
04-03-2008, 11:54 PM
Is that HUD cluster for sohc or dohc?

EDIT: I see you say they're DOHC clusters. Does the HUD cluster work 100%? If so, payment ready!

icemhan_21
04-04-2008, 12:02 AM
is the 5 speed driveshaft off an s14? how much is it shipped to 37075?

burnn5
04-04-2008, 12:40 AM
my cluster quit working last week, do you have any that are around 159k miles?

240silvia
04-04-2008, 12:43 AM
my cluster quit working last week, do you have any that are around 159k miles?


I believe I do, if not I'll tell you how to swap the mileage.

The driveshaft is off an S13, I don't really want to part out the 5 speed stuff just yet.

The HUD is for a SOHC, I should of said that. And it has the resistor issue if I remember. When the car warms up, it comes on.

Densetsu Motorsports
04-04-2008, 12:49 AM
How much for all the 5 spd parts shipped to 85714?

240silvia
04-04-2008, 12:51 AM
How much for all the 5 spd parts shipped to 85714?

are you wanting the trans, driveshaft, flywheel, shifter and knob?

alexander500
04-04-2008, 12:57 PM
How much for the SR cold side pipe shipped, paypaled and everything to 21758?

pitchlock
04-04-2008, 03:30 PM
Are the ecu's for a s13 of s14?

If they are for an s13 I'll take one how much shipped to 29680 and paypal?

meth
04-04-2008, 04:45 PM
PM sent about a/c and a guage cluster. :bigok:

BenArtM80
04-04-2008, 06:21 PM
if you decide to part the 5 speed stuff, but I'll take the flywheel (with bolts?), I'm also interested in the SR coldpipe and I live in NC currently

BoostedCoupe
04-04-2008, 06:47 PM
wanna sell the stock shift knob?

240silvia
04-05-2008, 01:12 AM
I have replied to all pm's.

The ECU's are ALL S13's

On the SR coldpipe, the couplers ARE 4 ply couplers.

I am off on Monday and Tuesday. So, I will get EVERYONE a shipping quote on Monday, I'll take payment Monday Night, and I'll ship out on Tueday!

I'm going to wait a few weeks on the 5 speed stuff. If it doesn't sell by then, I'll part the stuff out. And YES, I do have bolts for the flywheel. A $35 value I might add, lol.

burnn5
04-05-2008, 01:30 AM
ill take a cluster then if you have one the works well and around 159k if you can get me a pic and a shipping quote to oklahoma city, ok 73139
burnn5 (at) yahoo (dot) co m

thanks,
-phill

240silvia
04-07-2008, 04:38 PM
ALL pm's and post replied via private message with pricing! Parts are packaged up ready to go out tomorrow.

240silvia
04-08-2008, 12:45 PM
everything that has been paid for has been shipped! I still have a lot of stuff available.

pitchlock
04-09-2008, 07:25 PM
Got the ECU today. Great guy to deal with. Thanks a bunch. (free bump)

gtir007
04-09-2008, 09:28 PM
i'll take the hks flange- shipped to 07108 , paypal info- thanks

chad91s13
04-09-2008, 10:28 PM
i need a s13 gauge cluster for my s13 dohc
how much shipped to 92867

240silvia
04-11-2008, 12:39 AM
all posts and pm's replied. Everyone else should have their stuff by now. Feedback????

gtir007
04-17-2008, 11:29 AM
bump for a excellent seller

burnn5
05-06-2008, 02:17 AM
still dont have my cluster. what did the shippers tell you?

burnn5
05-09-2008, 03:17 AM
last chance before i go to paypal for my $$ back.
id really like to have that cluster instead of the $$..

UNDFTD
05-09-2008, 06:04 AM
dam you must be a scavenger at the yards.