View Full Version : Simple question.
LA_phantom_240
03-16-2008, 12:16 PM
Broke my EGR tube while removing stock header, so I'm going to JB weld the bung for it on the header, and just not have EGR. Do I also need to plug the tube itself that leads to the EGR, or can I leave that open?
Jung2
07-07-2008, 02:56 AM
I'm in the same situation. My EGR pipping did not allign with my new header. I decided to cut the pipe and and used a rubber cap to block off the pipe the goes to the EGR (note: I did not remove the EGR) I'm wondering is this okay? Or should I remove the EGR and use a block of plate?
downshift_sideways
07-07-2008, 02:58 AM
You have to block the line off aswell it ports to the intake manifold.
You should just take the time. to eliminate your entire EGR vacuum lines.
DALAZ_68
07-07-2008, 03:25 AM
I'm in the same situation. My EGR pipping did not allign with my new header. I decided to cut the pipe and and used a rubber cap to block off the pipe the goes to the EGR (note: I did not remove the EGR) I'm wondering is this okay? Or should I remove the EGR and use a block of plate?
if u have a DOHC i have the block off plate for the mani:coold:
vBulletin® v3.8.11, Copyright ©2000-2021, vBulletin Solutions Inc.