PDA

View Full Version : Drive shaft tech questions & help.

racer98
03-05-2008, 08:14 PM
I wanted to know if some one can share the Dimesions as far as

LXWXH goes for a SR20DET drive shaft, and also can I use one from a KA24DE or is it an E ?


thanks.
g6civcx
03-05-2008, 08:23 PM
I had a redtop S13 SR and I used the stock driveshaft from a sohc non-abs. I also ordered an S13 driveshaft from the Drive Shaft Shop and they spec their shafts by ABS or nonABS, and not e or de.
racer98
03-05-2008, 08:28 PM
thanks for that info. would any one have the acutal measurements. need to also check on shipping.
94_240sx
03-07-2008, 07:01 AM
thanks for that info. would any one have the acutal measurements. need to also check on shipping.

I have a stock s13 manual shaft w/o ABS out of the car and also have Shaftmasters 1 piece aluminum shaft. I can measure them tonight. Shaftmasters shaft is like 5mm shorter than the stock one. You want overall length from tip to tip. Right?
g6civcx
03-07-2008, 07:04 AM
Why don't you measure your car and then call Drive Shaft Shop to discuss the rest?
ManoNegra
03-07-2008, 07:05 PM
I wanted to know if some one can share the Dimesions as far as

LXWXH goes for a SR20DET drive shaft, and also can I use one from a KA24DE or is it an E ?


thanks.

Dimensions for all shafts - ABS and non - were posted on FA a few years back.
E or DE shafts work, match abs on non depending on your car.
You may need to trim a bit of the rubber sleeve at the end to make it fit.
If you need one built then:

Driveline Service
15639 1/2 S Broadway
Gardena CA, 90248
(310) 515 4704

I got one built from them, recommend by Marco from sr20store.
racer98
03-07-2008, 07:12 PM
Dimensions for all shafts - ABS and non - were posted on FA a few years back.
E or DE shafts work, match abs on non depending on your car.
You may need to trim a bit of the rubber sleeve at the end to make it fit.
If you need one built then:

Driveline Service
15639 1/2 S Broadway
Gardena CA, 90248
(310) 515 4704

I got one built from them, recommend by Marco from sr20store.



I just need the sizes. Building a RB26 -----) RB31 set up with some nice power. making something light weight but will be testing out as how light I can make it before it starts to snap with the power im going to load up on it.

so just a stock S13 SR20DET RWD one I need a measurement tip to tip.
ManoNegra
03-07-2008, 07:29 PM
Gotcha, wasn't sure what you were trying to do.