Log in

View Full Version : AN fittings in Greddy Relocation Kit?


ScottMan
02-14-2008, 10:01 AM
I am looking to use my greddy remote filter mount with my AN/Braided relocation kit. I'm using the Circuit Sports block plate so I'm using -8 AN lines.

What I'd like to know is does anyone happen to know what size adapter I need for the remote mount? I'm guessing it's going to be 3/8 NPT to -8 AN but I wanted confirmation if possible.

Anyone done this?

Slidin240Wayz
02-14-2008, 10:07 AM
Somebody posted the instruction manual of the greddy block recently.

I would look for that for the details you request.

ScottMan
02-14-2008, 11:28 AM
^I think I found what you are talking about in my initial searching. Oil cooler instructions I think? I studied it but couldn't seem to figure out a size on the fitting. I could just be a moron but I couldn't find it.

+1 for the help though! Thanks!