Tie Rod End Thread Size

[greddyguy]

i dunno if anyone will know, but what size is the rod? im thinking its a 1/2"-20

im just wondering because i found some pillowball rod ends at work that i want to use to replace my shitty megan racing rod ends. just the spherical bearing part

[racepar1]

My kazama ends were 14mm x 2.0 threads, which are pretty much impossible to find in a high angle end. In my opinion the kazama ones are no better than the megans though! Fuckin SHITTY! bearings!!! You need to get a thread guage and some calipers and figure out the size. If they are metric threads good luck! They are pretty difficult to find and when you do find them they will be special order. On the other hand if they are SAE they they will be easy to find and cheap. Once you figure out the threads go to www.bakerprecision.com (http://www.bakerprecision.com) They can most likely get what you need.