Please Help: Blitz Boost Control

[vbl]

http://www.geocities.com/kpk_4_eva/blitz.JPG
(sorry kinda bad draw)

Hi everyone, I have boost creep and my external wastegate don't hold boost. As the picture show, that is how i install into my SR. but i read the manual it said if i use external wastegate i should install different from internal wastegate.

The question is should i drill and install a nipple to the cold pipe before the throttle body or after the throttle (as i'm doin in the picture). Please help i'm really confuse right now.

I'm doing GT2871R with External Wastegate (Delta Gate). Can u guy show me how to get better Boost responce and spool faster. Also show me how to install my Blitz Boost Controller in CORRECT Way, thank you very much.

Blitz manual: http://www.team3s.com/Blitz%20SBC%20i-D%20manual.pdf

[jesse_lawhorn]

I have a Blitz SpecR boost controller and here is how its set up. The solenoid is the same, so it should be the same. The wastegate should go to the OUT on your solenoid. There should be a boung just after your turbo that should go to the IN on your solenoid ( i had to install one just before my hot pipe). Maniflod pressure is your vacuum so that goes to your Blitz controller. The way you have it on your Pic looks like the IN on your solenoid is wrong.http://www.geocities.com/kpk_4_eva/blitz.JPG

[slw240sx]

how old is that deltagate? I would say thats your problem, but thats only because i have personally delt with a handful of them break.

did you set the controller up for external gate?
are you using the side port?
what vacuum port are you running it off of at the intake?

i have this same controller and it works great.