street240
07-13-2007, 06:30 PM
I have a Manifold/Turbo/WG/ and DP for an SR20DET to run a bottom mount T3/T04 setup. The whole setup is complete bolt on.
*The Manifold - This is the stock cast manifold ported, and has been modified for t3 flange. This setup produced 377rwhp and 12.04 at the track
*The DP - This is a custom made down pipe that will bolt up without any modifications. It has a 5 bolt flange with a swing valve for the internal wastegate. It will also clear the power steering (http://www.zilvia.net/f/showthread.php?t=147802#).
*Custom made intake (http://www.zilvia.net/f/showthread.php?t=147802#) pipe to place the air filter closer to the front, instead of the block.
*Turbo (http://www.zilvia.net/f/showthread.php?t=147802#) - Air Research Garrett T3/T4 50 trim, recently rebuilt and has less than 30 miles since rebuild. This setup is good for mid-high 300's at the wheel. 0 shaft play and quick spool
Additional turbo info- T04 50 trim "AIRESEARCH" Compressor, 0.50 a/r * center section: Dynamic seal, oil cooled, Hi precision balanced * T3 turbine, 72 trim wheel 0.48 a/r housing
500 bucks for the entire setup
Tons of pics of everything available (I can’t get to hosting sites from this pc)
[email protected] ([email protected]) for fast response
I am paypal verified and 100% feedback “mitdrx” on ebay.
*The Manifold - This is the stock cast manifold ported, and has been modified for t3 flange. This setup produced 377rwhp and 12.04 at the track
*The DP - This is a custom made down pipe that will bolt up without any modifications. It has a 5 bolt flange with a swing valve for the internal wastegate. It will also clear the power steering (http://www.zilvia.net/f/showthread.php?t=147802#).
*Custom made intake (http://www.zilvia.net/f/showthread.php?t=147802#) pipe to place the air filter closer to the front, instead of the block.
*Turbo (http://www.zilvia.net/f/showthread.php?t=147802#) - Air Research Garrett T3/T4 50 trim, recently rebuilt and has less than 30 miles since rebuild. This setup is good for mid-high 300's at the wheel. 0 shaft play and quick spool
Additional turbo info- T04 50 trim "AIRESEARCH" Compressor, 0.50 a/r * center section: Dynamic seal, oil cooled, Hi precision balanced * T3 turbine, 72 trim wheel 0.48 a/r housing
500 bucks for the entire setup
Tons of pics of everything available (I can’t get to hosting sites from this pc)
[email protected] ([email protected]) for fast response
I am paypal verified and 100% feedback “mitdrx” on ebay.