AHH...stance help plz

[240love]

Ok so not long ago i bought stance gr basics and when they were delivered i opened the box and found no camber plates on them. I call them and let them know the situation and they send me the plates. So then i took them to a local shop here to get them assamblemed and all that was done was a dam bolt that needed to be tightened with an air gun according to them. So today i put them on the car and they look odd to me, a lil unsafe for a reasonl. I look trough the box and found these little metal plates that im sure go there somewhere, also that bolt that was tighetend with an air gun... well my brother undid that bolt with his hand so that was kinda weird. Anyway can someone help me i need to know where that metal plate goes(i am missing one so too so ill call stance)
this is when i though they looked unsafe
http://i22.photobucket.com/albums/b309/240sx_/IMG_0997.jpg (http://photobucket.com)

this is the bolt that my brother undid with his hand
http://i22.photobucket.com/albums/b309/240sx_/IMG_0996.jpg (http://photobucket.com)
little metal plate i found on box
http://i22.photobucket.com/albums/b309/240sx_/IMG_0995.jpg (http://photobucket.com)
after i took them off
http://i22.photobucket.com/albums/b309/240sx_/IMG_1001.jpg (http://photobucket.com)
Is that were the plate goes????
http://i22.photobucket.com/albums/b309/240sx_/IMG_1004.jpg (http://photobucket.com)

[Addicted2Kouki]

no. take a look at your stock suspension. its the answer to everything.

you'll see it there under the tophat.

[240love]

thanks ill take a look tomorrow...was that bolt supposed to be really tight?

[KiDyNomiTe]

There is a plate under the bushing and a plate on top of the bushing, make it tight so it squeezes the bushing down.

[cgguy]

Looks good to me. You have to have something between the rubber bushing and the top nut. Take a look at your rears...they should have the same setup with the rubber bushing.

Stance is so far behind orders it sounds like they are getting pretty sloppy with things.

[redZENKI]

So what should the top bolt be torqued at?

[overb0ost]

55-60lbs iirc

[240love]

thanks guys......

[onepuff]

i just got the same coilovers that didn't come with the camber plates either. Email stance, they sent me a set of pics that show exactly how the camber plates should be installed. If you don't get a reply from them i can send you the pics.

[240love]

ok so i got everything figured out thanks to onepuff...im missing one of the top washers, how safe is it to put them on without the washer till i get the new one ?