wide body question

[swang]

when u get rear wide fenders and u flush the gas cap out

so it looks something like this

http://memimage.cardomain.net/member_images/5/web/701000-701999/701654_40_full.jpg

http://memimage.cardomain.net/member_images/5/web/701000-701999/701654_41_full.jpg

how do u fill up gas?
if u covered ur gas holey thingy :loco:

and yes i know the gas is on the right side. :)

[rps13drift]

probably a fuel cell mounted in the trunk/hatch

[3-240's-N-aMule]

ummm... Lol? Its a fiber lid u place over ur gas door. Its edged slightly on the hinge part to allow it to open fully when u pop the gas door. Or u could shave it and reroute ur gas lid to some other spot.

[ThatGuy]

If you had actually looked at a set of overfenders, you would've figured this out on your own. :duh:

"Flushing the cap out" means you make the gas cap flush with the new fender, not make it dissappear. If you SHAVE the gas cap, yes you would need to find a new way to fill up.

[20 til 3]

your going to have to cut a hole and run it elsewhere... imo i would put a latch on the pass rear tail light so it swivles out(similar to a tri-5 chevy) so its hidden and you wont have a bad gas smell inside the car at times, it isnt to hard, your going to have to cut a 2" hole where the gas hose runs up to the factory location and just run hose from there ... inside the car and to wherever you want to have it... you could easily have it so you just have to pop the hatch and its right there, but if you already shaved the spot... i'd think you want it to be clean... so run it behind the tail light and make the tail light swing open(like a screen door) and have it mounted there ... thats what i would do neways