PDA

View Full Version : Need Help with z32 e brake assembly


drift_ricer
04-15-2007, 09:59 PM
while install the z32 e brake. I got stuck on the z32 backplate and e drum, there's a spacer between them that I can not bolt on it. This is call the z32 block anchor. I searched other forum and found that only 90's 300zx is perfect fit into 240sx. other different has model and year doesn't fit also. I don't know if I am saying it right, but any here a pic hopefully helpful. any idea.

http://i126.photobucket.com/albums/p112/sxj6151/NICO/IMG_4493.jpg
http://i126.photobucket.com/albums/p112/sxj6151/NICO/IMG_0001.jpg
The thick one with number label 92 is what's I am looking for.


http://i118.photobucket.com/albums/o107/Silvia_Convertible/gap1.jpg

PLease help out...if anyone has the thick block anchor, please pm. I can buy it, thanks

projectRDM
04-15-2007, 10:06 PM
Use a stack of washers on either side. Works perfect, I've done it numerous times. Just make sure the kingpin doesn't rotate too much when fully tightened or it will hit the inside lip of the rotor.

drift_ricer
04-16-2007, 12:15 PM
ok I try it tomorrow. you sound right.

UNISA JECS
04-30-2007, 01:57 PM
What works perfectly is 2 axle nut washers stacked together any nissan axle nut washers will work and be the perfect height you need when stacked together.