I need help with my whiteline bushings

[srJOEYdet]

I am ready to install my whiteline camber correction bushings, but i am having trouble getting them in. I noticed that the kit came with a red lubricant, but did not mention it in the installation instructions. I wanted to know a method to get theese in in which the bushing doesent push the second rubber sleeve out. I know one of you has put theese on. Please help! Also, doesthe lube go inside the bushing for the bolt, or is it to help them slide into the controll arms?

Joey

[HKrpS13]

I also need help about bushings. On the T/C rod bushing, hoe the hell do you get the bolt out? I think mines stuck. Any idea would help.

[bbp]

Joey,

Are you having fun yet??

Use ALL the grease they provide, lube the crush tube and the inside of the bushings.  If you have a large enough vise you can use it to press the new bushings in.  

Take a socket the same diameter as the crush tube on one side.
On the other side get another socket the same size as the outer shoulder of the bushing.

You may need some extra hands to hold this all together in the vise.  Put the assmbly in the vice with the vise clamping on the two sockets and slower push them together.  Voila!

As always in life...use lots of lube <img src="http://www.zilvia.net/f/iB_html/non-cgi/emoticons/wink.gif" border="0" valign="absmiddle" alt=';)'>

[srJOEYdet]

Thanks.. I'm gonna go get lubed up. I mean The bushings...

Joey <img src="http://www.zilvia.net/f/iB_html/non-cgi/emoticons/thumbs-up.gif" border="0" valign="absmiddle" alt=':thumbsup:'>