dave240sx
07-30-2002, 10:34 PM
ok I'll admit it. I bought this "Advanced timing kit" off of ebay for $6.00 Not a lot so I'm not sweating it if it doesn't work. Anyway It came with a "Resistor" and directions.
Here's the directions
1.Disconect Battery
2. Locate the IAT (Intake Air Temperature)Sensor.
3. Unplug IAT sensor by lifting tap and pulling off.
4.Take resistor supplied bend in U shape
5.Put one end of the resistor into the medal on the IAT Sensor
6. Tape resistor to IAT with electrical tape
7.Reconnect Battery
ok
Q#1: Should I even try?
Q#2: If so where is the IAT Sensor.
(http://www.240sx.org/links/installs/aem-intake/index.htm)go here. On step 2 It says disconnect the MAF and the IAT and then has 2 pictures which picture is the IAT?
I'm sure I'll get slammed for this since I bought it over ebay but oh well I don't really care. It was only $6.00
-dave-
Here's the directions
1.Disconect Battery
2. Locate the IAT (Intake Air Temperature)Sensor.
3. Unplug IAT sensor by lifting tap and pulling off.
4.Take resistor supplied bend in U shape
5.Put one end of the resistor into the medal on the IAT Sensor
6. Tape resistor to IAT with electrical tape
7.Reconnect Battery
ok
Q#1: Should I even try?
Q#2: If so where is the IAT Sensor.
(http://www.240sx.org/links/installs/aem-intake/index.htm)go here. On step 2 It says disconnect the MAF and the IAT and then has 2 pictures which picture is the IAT?
I'm sure I'll get slammed for this since I bought it over ebay but oh well I don't really care. It was only $6.00
-dave-